IRC812
1280×1024 Indium Antimonide (InSb) MWIR Infrared Camera
The IRC812 provides the superior performance of a cooled MWIR sensor in a high definition imaging camera. This 12 micron camera provides superior resolution and is unmatched in sensitivity, ultra-low noise and no crosstalk making this camera perfect for Target Signature Analysis, Process Analysis and Medical Imaging applications
IRC812 Specifications
| Detector | |
| Detector type | Indium Antimonide (InSb) |
| Spectral response | < 1.0µm to 5.3µm |
| Resolution (pixels) | 1280 x 1024 |
| Pixel pitch | 12µm |
| Imaging Electronics | |
| Frame rate @ max window size | 119 Hz |
| Integration time | < 150 ns to full frame |
| Dynamic range | 14-bits with 13-bit option to increase frame rate at small window sizes |
| Windowing | User defined in 4×1 increments; min width=320, min height=32 |
| Integration type | Snapshot, automatic selection of integrate while read or integrate then read |
| Ultra low latency sync | Sync I/O, integration out |
| Image data | Simultaneous Camera Link & Gig-E |
| Communications | Serial over Camera Link & Gig-E |
| Software control | Cross platform GenICam compliant |
| Performance | |
| NEdT | < 30mK |
| Well capacity (electrons) | 2M |
| Operability | 99.6% |
| LN2 hold time | > 8 hours typical, > 4 hours with optional cold filter wheel |
| Optics | |
| Camera f/# | f/2.3, f/3.0 & f/4.0 standard; custom cold shields available on request |
| Cold filter | 3.0µm – 5.0µm or no cold filter standard, optional CO2, SWIR or custom filters on request |
| Lens mount | Bayonet for 7, 13, 25, 50, 100 & 50/250 mm lenses; bolt hole pattern for non-standard lenses |
| Optional filter wheel | Motorized four position cold filter wheel; 25.4mm diameter x 1.0mm thick filters |
| General | |
| Power @ 24 VDC | 12 watts |
| System weight | < 7 pounds |
| Size | 3.7″ x 8.1″ x 11.8″ |
| Operating temperature range | -40C to +55C (-40°F to +131°F) |
| Storage temperature range | -55C to +80C (-67°F to +176°F) |
| Environmental rating | IP-51 |
| Mounting holes | 2x 1/4-20 & 4x #10-24 |
Specifications are subject to change without notice.
